Page 1
Operation Manual Drywall Sander 62830 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
Page 2
All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli- ents take some basic safety precautions when using this device. Please read the operation in - structions carefully and make sure you have understood its content. Keep these operation instructions safe.
Page 4
Do not place your hands on the sanding disk of the tool and make sure to stand still during its operation. Always make sure the sanding disk is tightly connected to the device and the necessary con- nections. ...
Application This device is a hand-operated electric tool and is mainly intended for working on chalk surfaces, such as inner walls, ceilings and outside walls. Remove the lime slurry from the wall and smooth its surface in order to potentially increase the effi- ciency and quality of your work.
Page 6
Description Description Upper cooling element Speed regulator switch Heavy duty engine Power switch Rotary disk Dust bag connection External carbon brush Side handle Handle LED light Speed regulator Accessories Dust bag Suction hose 3. Side handle 4. Adapter 5. Sanding disk 6.
Page 7
Installation and Sanding Disk Exchange Attention! Always ensure to not only turn the device off, but to remove it from its power source by properly disconnecting its power cord from the socket outlet or extension cable before installing or re- moving sanding disks.
Edge Grinding In order to facilitate the process of grinding edges, simply remove a part of the rotary disk cover. Suction Settings Exchanging Carbon Brushes The device is delivered with a set of spare brushes that can be used to replace the pre-installed car- bon brushes once they are worn out.
Cleaning The tool has to be cleaned after every use. It is thereby recommended to perform the cleaning shortly after the device has been used. Regular cleaning can help to prolong the working life of the device. It is recommended to clean terminal sets and components of the electric motor without the use of water.
All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.