Advertisement
Quick Links
Operation Manual
Electric Polisher
62883, 62884
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 62883
Summary of Contents for WilTec 62883
- Page 1 Operation Manual Electric Polisher 62883, 62884 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Use clamps or another convenient method to secure and support the workpiece on a stable platform. Holding the workpiece by hand or pressing it against the body may cause it to become unstable, resulting in loss of control and injury. © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 3 http://www.WilTec.de...
- Page 4 Do not run the tool when it is not in use. Operate the tool only when handheld. • Do not touch the workpiece immediately after operation. It may be very hot and could burn your skin. © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 4 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 When replacing the worn polishing pad, make sure that the new polishing pad and the pol- ishing wheel are aligned so that they both run round. © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 5 http://www.WilTec.de http://www.aoyue.eu...
- Page 6 Excessive pressure will affect the quality of the work and also wear the polishing wheel. © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 1200 Max. (no-load) speed ( ⁄ 3000 Grinding wheel diameter (㎜) Support plate diameter (㎜) 150, 180 Polishing fleece diameter (㎜) Polishing sponge diameter (㎜) © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Exploded drawing and parts list © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 8 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 9 Straight speed switch Large gear Rivet (2×10) Baffle ring (⌀ 32 mm) Small spring of switch Front cover Trigger Screw (M4×16) Type plate Dust cover © by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 9 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 10 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registered in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...