Quantel Ultra Big Sky Laser Series User Manual page 88

84 | Contents | Troubleshooting
Interlock ICE Front Panel
Value Message
IF3 00010000 low frequency
IF3 00001000 high frequency
IF3 00000100 Capacitor not
discharged
IF3 00000010 simmer disabled
time out delay
expired
NOTE: To clear an interlock message, press the "Cursor
Up" or "Cursor Down" button on the Remote Box.
Version M 22-April-2012
Possible Cause
The external trigger Decrease the frequency of the external
input frequency is signal generator
less than frequency
or
minimum value.
increase the setpoint for frequency.
Contact Quantel Customer Service for
details on disabling frequency checking.
The external trigger Either increase the frequency of the
input frequency is more external signal generator
than the maximum
or
frequency value.
decrease the set-point frequency.
Contact Quantel Customer Service for
details on disabling frequency checking.
The flashlamp capacitor You should not attempt to repair this
did not completely problem. Contact Quantel Customer
discharge after the Service for repair.
flashlamp turned off.
CAUTION: This
is due to a fault
in the charging
system and may
be hazardous.
The simmer timeout has You should not attempt to repair this
expired. problem. Contact Quantel Customer
Service for repair.
Solution/Suggestion
|
Ultra
Description
When operating in External flashlamp
triggering mode, the ICE450 compares the
input trigger frequency to the programmed
frequency as viewed on the Remote Box.
An interlock condition occurs if they do not
match.
When operating in External flashlamp
triggering mode, the ICE450 compares the
input trigger frequency to the programmed
frequency on the Remote Box. If they do
not match, an interlock condition occurs.
The system controller monitors the voltage
on the PFN capacitor. The system displays
this interlock if there is an unsafe residual
voltage remaining on the PFN capacitor.
You should not attempt to repair this
problem. Contact Quantel Customer
Service for repair.