Quantel Ultra Big Sky Laser Series User Manual page 14

10 | Contents | Setup
Connecting a Rack ICE450
CAUTION: Do not power up the laser
system before thoroughly reading the
installation and operation instructions.
1. Verify that the ICE key switch is turned OFF.
2. Connect the I/O cable between the ICE rear
panel and the Laser Head. All connectors
are unique and keyed to ensure proper
connection. Secure all non-locking connectors
using the captive fasteners.
CAUTION: These connections carry high
voltage and high current. It is necessary to
fully insert the mating connector and fully
engage the collars or screw locks or
interlock faults may result.
3. Remove the blue plastic shipping covers from
the coolant ports. Keep them for reuse.
4. Connect the coolant lines between the back
panel of the ICE and the Laser Head. Connect
red to red and blue to blue. Coolant flows from
the ICE into the Laser Head via the blue hose
and returns to the ICE via the red hose.
5. Verify that the Emergency Stop switch on the
Remote Box is in the OUT position.
6. Connect the Remote Box to the ICE front panel.
7. Connect the AC Mains power cable from the
ICE back panel to 100-240 VAC, 50/60 Hz
power.
CAUTION: Ensure the system is connected
to the proper voltage. The voltage rating is
marked on the ICE back panel. Operating the
system at the incorrect voltage may damage the
system. Ensure that the power outlet used is prop-
erly grounded.
Version M 22-April-2012
TO
100-240 VAC,
50/60 HZ
POWER
Figure 3: Connecting a Rack ICE450 Ultra System
|
Ultra
EMERGENCY STOP
COOLANT
LINES
I/O CABLE