Installation Of A Pto To A Split Shaft Mounting Instructions 6 Or 8-Bolt Applications - Parker 732 Series Owner's Manual

Bulletin HY25-1900-M1/US
Installation Instructions
Mounting PTO to Split Shaft for 6 or 8-Bolt Applications
1. Drain the oil from the transmission, and remove the PTO
aperture cover plate (Fig. 1).
2. Discard the cover plate and cover plate gasket. Clean the
aperture pad using a putty knife or wire brush (Fig. 2).
NOTE: Stuff a rag in the aperture opening to prevent dirt from
entering the transmission while you are cleaning it.
3. Using your hand, rock the PTO drive gear in the transmission
(Fig. 3) and the driven gear in the PTO assembly (Fig. 4).
Rocking the gears provides two important factors.
A. It shows you the amount of backlash that has been
designed into each unit.
B. It is helpful in establishing the proper backlash when
installing the PTO.
4. Install the proper studs in the PTO aperture pad using a stud
driver (Fig. 5).
5. Where holes are tapped through the transmission case, use
Permatex or an equivalent to prevent leaks.
NOTE: Avoid contact of Permatex with automatic transmission
fluid in automatics. Always check to be sure the studs do not
interfere with transmission gears.
Owner's Manual
Legacy Split Shafts and Gear Box
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
15 Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA