Parker 732 Series Owner's Manual page 23

Bulletin HY25-1900-M1/US
Installation Instructions
Cable Control Installation Instructions (Continued)
6. Determine from which direction the cable must come in order for the unit to be disengaged when the knob is
all the way in.
NOTE: The shifter must always be installed in the following manner:
*
CABLE IN: PTO DISENGAGED(6A): OUT OF GEAR POSITION
CABLE OUT: PTO ENGAGED(6B): IN GEAR POSITION
* The wire shift cable should be installed so that when the cable (knob) is pushed all the way in, the PTO has
also moved the full travel of the PTO shifter, to the disengaged mode.
7. Install the wire control bracket found in either the 328380X or 328380-1X wire control parts bag [7].
8. Line the cable up with the wire control bracket and shifter lever (disengaged position) on the PTO cover
assembly [8].
NOTE: It may be necessary to change the position of the shifter lever on the PTO To do this, remove the shifter
cover from the unit. This will prevent the possible loss of the poppet and/or spring into the transmission if the shifter
post assembly should be pushed through the cover when reinstalling the lever.
9. Shift the PTO to the engaged position to see how much of the cable casing must be cut to allow the lever
enough travel to shift in and out completely. The casing need only go just beyond the bracket, whereas, the
wire must be long enough to go through the swivel pin in the shifter lever [9].
NOTE: In some instances the cable control may not be long enough. Chelsea has available four longer lengths
than the standard ten-foot cable. These come in five foot increments (i.e., 328346-15X = 15-foot cable).
10. When the length of the casing has been determined, pull the wire back through until the case can be cut
without cutting the wire. Use a hacksaw or heavy pair of side cutters to cut the casing.
NOTE: The cable can be held by a bench vise as long as the jaws are not tightened to the point where the case
mushrooms. If a vise is not accessible, a pair of vise grips will do the job.
Owner's Manual
Legacy Split Shafts and Gear Box
19 Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA