Parker 732 Series Owner's Manual page 25

Bulletin HY25-1900-M1/US
Installation Instructions
Cable Control Installation Instructions* (Continued)
ø.750 (For Drill Size)
379640
Booted Connector
Normally
"Off"
380515
Indicator Switch
White Nylon
or
Nomally "Off"
Normally
379640
"On"
Booted Connector
379652
Indicator Switch
Black Plastic
Normally "On"
CAUTION: Indicator switches are capable of 0.5 amps maximum.
NOTE: All wires and cables must be clear of heat source and moving parts.
13. Shift the PTO to ensure enough casing has been removed to allow full gear engagement.
14. Install the wiring for the indicator light using the schematic above (SK-286 Rev G).
NOTE: Check both the cable and indicator light wires to be certain that they are not near the exhaust system or
any moving parts. Carefully fasten to stationary parts of the vehicle if necessary.
15. Shift the PTO The following should be adhered to:
[15A] CABLE IN: PTO DISENGAGED: LIGHT OUT
[15B] CABLE OUT: PTO ENGAGED: LIGHT ON
NOTE: The PTO should be checked for continuity as per the instructions in this manual.
NOTE: Cable must be rigidly mounted-possibly to the transmission within 12-24" of the P. T. O.
* All six bolt wire shifts with the exception of the reversible, dual shift units, and some gear boxes.
Owner's Manual
Legacy Split Shafts and Gear Box
378978 (12 Volt)
379005 (24 Volt)
Indicator Light
379252 Butt Connector
379252
Butt Connector
379900
Fuse Holder Ass'y
w/ 10 AMP Fuse
21
NOTE: All Wires and
Cables Must be Clear
of Heat Sources and
Moving Parts
68-P-18
Control Plate
Battery
Indicator Light Installation
Sketch (SK-286 Rev G)
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA