Status Codes - Siemens SIMATIC RF1000 Series Operating Instructions Manual

6.4

Status codes

The following table contains a list of the status codes of the VHL command set divided up
into command groups.
Table 6- 45
Value
USB
syscmd
0x0000
vhl
0x0101
0x0102
0x0103
0x0104
0x0105
0x0106
0x0107
0x0108
0x0109
0x010A
0x010B
0x010C
Autoread
0x0501
0x0502
0x0503
0x0504
0x0510
SIMATIC RF1000
Operating Instructions, 02/2019, C79000-G8976-C432-04
General status codes
Variable
RS232
0x00 STATUS_OK
0x01 NOTAG_ERR
0x02 CARD_NOT_SELECTED_ERR
0x03 HF_ERR
0x04 CONFIG_ERR
0x05 AUTH_ERR
0x06 READ_ERR
0x07 WRITE_ERR
0x08 CONFCARD_READ
0x09 INVALID_CARD_FAMILY_ERR
0x0A NOT_SUPPORTED_ERR
0x0B VHL_FORMAT_ERR
0x0C VHL_HW_ERR
0x01 NO_MESSAGE_ERR
0x02 SCRIPT_RUNTIME_ERR
0x03 SCRIPT_SYNTAX_ERR
0x04 SCRIPT_NOT_IMPL_ERR
0x10 AR_DISABLED_ERR
Description
No error
Transponder does not exist or no response.
This status code requires reselection of the
card with the function "vhl_select".
The function cannot be executed because
no transponder is selected.
Communications problems with the tran-
sponder.
The structure of the VHL file is invalid or the
VHL file was not found.
Authentication error. The keys in the VHL
file are invalid (MIFARE) or the stamp in the
reader is invalid (LEGIC cards).
The communications sequence is success-
ful, but reading failed.
This value is currently not supported.
A transponder was recognized.
The required transponder type does not
match the transponder family of the current-
ly selected transponder.
The function is not supported.
Format error
Hardware problems during access (e.g. on
the reader chip)
No valid card / no valid transponder recog-
nized.
Runtime error detected during script execu-
tion.
Syntax error in the script
Scripts does not exist.
"Autoread" function is switched off.
Programming
6.4 Status codes
43