Appendix; Certificates & Approvals; A.1 Certificates & Approvals - Siemens SIMATIC RF1000 Series Operating Instructions Manual

Appendix

A.1 Certificates & approvals
Table A- 1
Labeling
Federal Communications
Commission
SIMATIC RF1000
Operating Instructions, 02/2019, C79000-G8976-C432-04
Country-specific approvals
Description
CE according to RED directive 2014/53/EU
CE according to RoHS directive 2011/65/EU
1) Part 15 Clause 15.105:
"Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
•
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
•
help."
2) Statement for Part 15 Clause 15.21:
"Changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user's authority to operate
the equipment."
3) Statement for FCC Part 15.19:
"This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
•
(2) this device must accept any interference received, including
•
interference that may cause undesired operation."
A
55