Status Codes - Siemens SIMATIC RF1060R Operating Instructions Manual

Value
0x0A
0x0B
0x0C
4.1.11

Status codes

The following table contains a list of the status codes of the VHL command set.
Value
0x0000
0x0101
0x0102
0x0103
0x0104
0x0105
0x0106
0x0107
0x0108
0x0109
0x010A
0x010B
Most of the status codes listed in the table above do not require reselection of the
transponder. The only status code that deviates from this rule is "NOTAG_ERR" This
requires reselection of the transponder by the application.
The functions are constructed so that if execution fails, they are automatically repeated. This
compensates any communications problems that may occur, e.g. due to bad RF signal
quality as a result of external influences.
SIMATIC RF1060R
Operating Instructions, 05/2017, C79000-G8976-C432-02
Variable
BRP_ERR_INSUFFICIENT_MEM
BRP_ERR_WRONG_HANDLE
BRP_ERR_WRONG_PARAMETERS
Variable
BRP_OK
NOTAG_ERR
CARD_NOT_SELECTED_ERR
HF_ERR
CONFIG_ERR
AUTH_ERR
READ_ERR
WRITE_ERR
CONFCARD_READ
INVALID_CARD_FAMILY_ERR
NOT_SUPPORTED_ERR
VHL_FORMAT_ERR
4.1 The functions of the DLL
Description
There is not enough memory to generate a new
session key.
The specified session key does not exist.
The parameters of a function are incorrect.
Description
No error
Transponder does not exist or no response.
This status code requires reselection of the card with
the function "vhl_select".
The function cannot be executed because no tran-
sponder is selected.
Communications problems with the transponder.
This value is currently not supported.
This value is currently not supported.
The communications sequence is successful, but read-
ing failed.
This value is currently not supported.
A transponder was recognized.
The required transponder type does not match the
transponder family of the currently selected transpond-
er.
This value is currently not supported.
This value is currently not supported.
Programming interface
19