Siemens SIMATIC RF1000 Series Operating Instructions Manual page 24

Programming
6.2 Programming via USB interface
The "CardTypeMask" parameter allows only specific card families to be selected. If you want
to select all cards supported by the hardware of the reader, you need to set the parameter to
"0xFFFF". The more significant half byte of the "CardType" parameter specifies the card
family (1-6) while the less significant half byte (X) refers to the recognized card type.
Table 6- 9
CardTypeMask
0x0001 (bit 1)
0x0002 (bit 2)
0x0004 (bit 3)
0x0008 (bit 4)
0x0010 (bit 5)
0x0020 (bit 6)
0x0800 (bit 12)
0xFFFF
Function call
int
vhl_select(
int Handle,
word CardTypeMask,
bool Reselect,
bool AllowConfig,
byte * CardType,
int * Status
);
Table 6- 10
Parameter
vhl_select
24
Assigning the card types
CardType
0x1X
0x2X
0x3X
0x4X
0x5X
0x6X
0xCX
0xFF
Description of the parameters
Description
With this parameter you select a card located in the antenna field.
Handle The session key returned by the function "brp_open_usb_session".
CardTypeMask With this parameter you specify the card family to be recognized. If you
want all card families to be recognized, set the parameter to the value
"0xFFFF".
Reselect The parameter decides whether the card should be reselected.
AllowConfig This value is "true" when a configuration card is to be read. In normal oper-
ation, the value must be set to "false" to prevent an unintentional ac-
ceptance of the reader configuration.
CardType The returned value indicates the card type.
Card family
ISO 14443 A / MIFARE
LEGIC Legacy (only for RF1070R)
ISO 15693
ISO 14443 B
Reserved
Reserved
LEGIC Prime (only for RF1070R)
All card families
Operating Instructions, 02/2019, C79000-G8976-C432-04
SIMATIC RF1000