Mounting Dlx-Rem500 To Swing-Away Remote; Holder; Mounting Primary Remotes To Nucleus Midline - Invacare Modulite Service Manual

Loosen screws B on gripper clamp A.
4. Remove gripper clamp A.
Installing
1. Install parts in reverse order.
5.8.4 Mounting DLX-REM500 to Swing-Away
Remote Holder
• 3 mm Allen key
• 4 mm Allen key
• Medium-strength thread locking adhesive
(Loctite 243 or similar)
1. Connect slip sticker A with joint arm B and insert
into support C.
2. Fix with sleeve nut D, washer E and screw F.
Apply thread locking adhesive to screw F.
3. Insert locking bolt H and compression spring I
through support C and joint arm B.
4. Fix with locking knob G and grub screw J .
Apply thread locking adhesive to grub screw J.
1604311-G
Fig. 5-7
5.
Insert bracket O into joint arm B, clamp ball N and
clamp ring M.
Fix with screws L.
6. Mount remote T to support plate S and clamping
bush R with washers Q and screws P.
5.8.5 Mounting Primary Remotes to Nucleus
Midline Holder
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod,
can lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.
Mounting DLX-REM110, DLX-REM2XX, DLX-REM400
• 4 mm Allen key
• 8 mm wrench
Service
Fig. 5-8
27