Emptying The Dust Cup; Cleaning And Replacing The Filters - Shark Navigator Swivel Pro Complete NV150 Series Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, pull up on the dust cup
release button located on the top of dust cup
handle. Tilt dust cup forward, then lift to
remove.
To remove collected debris from Lint Screen,
press the top release button and lift the
handle to open the dust cup. Gently brush
lint screen to clean.
s h a r kc l e a n . c o m
Press the release button to open bottom of
dust cup.
To reinstall, place the bottom of dust cup
onto the pod and then tilt until it clicks into
place.

CLEANING AND REPLACING THE FILTERS

CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To rinse filters, use cold water only to prevent damage from cleaning chemicals. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electronic parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Post-Motor
Filter HEPA Filter
Door
RINSE HEPA FILTER
EVERY YEAR
Tilt Filter Door and firmly pull it off. Press
tab at top of HEPA Filter and pull out filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
s h a r kc l e a n . c o m