Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark STRATOS CLEAN SENSE IQ MultiFLEX IZ862H Owner's Manual

MAINTAINING YOUR VACUUM

EMPTYING THE DUST CUP

Press the wand release button to detach the
handheld vacuum from the wand.
REMOVING AND CLEANING THE DUST CUP
To remove the dust cup from the handheld vac-
uum, press the CleanTouch Dust Cup Release
button near the handheld vacuum nozzle. Tilt
the dust cup and lift off to remove.
To empty dust and debris, hold the dust
cup over the trash receptacle, then slide the
CleanTouch Dirt Ejector slider forward.
s h a r kc l e a n . c o m
1
To empty the Dust Cup while it is attached
to the handheld vacuum, position the dust
cup over a trash receptacle and slide the
CleanTouch™ Dirt Ejector slider forward.
1
To clean the interior of the dust cup, rinse
it with water. Place it on its side with the lid
open to air-dry for at least 48 hours before
reinstalling.
Regularly rinse and replace the filters to maintain your vacuum's suction
2
power and to maximize the effectiveness of odor neutralization.
To clean filters, rinse them with water only. Allow all filters to air-dry completely for up to 48 hours before
reinstalling to prevent liquid from being drawn into electric parts.
Clean the pre-motor filters at least once a month and post-motor HEPA filter at least once a year. Tap off loose
dirt between washes when needed. More frequent cleaning may sometimes be necessary with heavy use.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only. The vacuum will not have suction if the post-motor
HEPA filter is not installed. Ensure that all filters are installed before using.
PRE-MOTOR FILTERS
Remove the dust cup, and pull the foam and felt
2
filters out of the back of the dust cup.
Pre-Motor Foam and
Felt Filter Kit
MAINTAINING YOUR VACUUM

CLEANING THE FILTERS

POST-MOTOR FILTER
Remove the dust cup. Pull the post-motor filter out
of the handheld vacuum.
Post-Motor HEPA Filter
sharkclean.com