Cleaning Modes - Shark Navigator Swivel Pro Complete NV150 Series Owner's Manual

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Power Off
I Hard Floor
For bare floors and small area rugs.
II Carpet
For carpets.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn off and unplug the vacuum and remove any
blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn the vacuum off and wait a
minimum of 45 minutes for the unit to cool down.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
The Suction Control Slider located on the top
of the handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT MODE
To engage Brushroll, place foot on floor
nozzle and tilt handle back firmly.
ABOVE-FLOOR—HANDLE
Press the Handle Release button and pull up on
the handle to detach it from the wand.
ACCESSORIES—HANDLE
Attach a cleaning accessory to handle or wand.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button and pull up on
the wand to detach it from the pod.
ACCESSORIES—WAND
s h a r kc l e a n . c o m