Available Accessories; Troubleshooting - Shark Navigator Swivel Pro Complete NV150 Series Owner's Manual

Table of Contents

Advertisement

AVAILABLE ACCESSORIES

Duster Crevice Tool
A
Two cleaning tools in one. The crevice tool
gives you extended reach to clean in tight
spaces, while the soft brush is ideal for
dusting delicate surfaces.
Wide Upholstery Tool
B
Wide cleaning path helps remove pet hair,
dust, and large debris from mattresses,
couches, curtains, lampshades, and other
delicate upholstered surfaces.
Upholstery Tool
C
Picks up pet hair, dust, and large debris
from mattresses, couches, curtains,
lampshades, and other delicate
upholstered surfaces.
Hair Removal Multi-Tool
D
A single convertible tool for cleaning tough
pet messes two ways: Use the rubber bristle
brush to remove hair from carpets. Or take
off the bristles to reveal an upholstery tool
perfect for cleaning couches and bedding.
Pet Power Brush
E
Designed to remove pet hair and ground-in
dirt from carpeted stairs and upholstery.
Under-Appliance Wand
F
Clean under and behind hard-to-move
appliances and furniture with this adjustable
36" tool. Flip the extension piece over to
clean the underside of appliances.
NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's
configuration. To order additional accessories, visit sharkaccessories.com.
s h a r kc l e a n . c o m
Vacuum is not picking up debris. No suction or light suction.
A
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
• If any string, hair, or carpet fibers are wrapped around the brushroll, remove the floor nozzle
cover and carefully cut debris with scissors and remove from brushroll. See Cleaning the
Brushroll section for more information.
B
Vacuum lifts area rugs.
• Make sure Power/Surface switch is set to Hard Floor (setting I).
• Rotate suction control slider to MIN.
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn
edges.
Brushroll does not spin in carpet cleaning mode.
• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
C
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
and turn on power.
• With the power on, recline the handle, which will automatically turn on the brushroll.
• Ensure that the Power/Surface switch is set to Carpet (setting II) for brushroll
to spin.
Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
D
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning the Filters).
3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and restart with the Power/Surface switch.
E
F
For all other issues, please call Customer Service 1-800-798-7398.

TROUBLESHOOTING

s h a r kc l e a n . c o m

Advertisement

Table of Contents
loading

Table of Contents