Cleaning Modes - Shark EVOPOWER CS850SM Series Owner's Manual

POWER AND DEEP CLEAN MODE
Press the On/Off button on the handle to
turn on power. The default mode is IQ mode.
To turn off power, press the button again.
NOZZLE LIGHT BAR
When in IQ Mode, the unit will automatically
adjust suction level depending on how much
debris it senses. The light bar on the nozzle
displays the suction level, and increases or
decreases as suction power changes.
sharkninja.sg
CONTROLS
ECO AND BOOST MODE
While cleaning, press and release the
Mode Selection Button on the underside of
the handle to enter ECO Mode to conserve
energy and increase runtime. Press the
mode selection button again to return to the
previous mode.
For an added boost of power, push and hold
the Mode Selection Button to enter Boost
Mode. The Boost light will turn on in this
mode. Release the button to return to IQ Mode.

CLEANING MODES

FLOOR NOZZLE
Use the floor nozzle for powerful cleaning on
both bare floors and carpets.
ABOVE-FLOOR HANDHELD
Detach the handheld vacuum from the wand
for quick and easy cleaning above the floor.
Press the buttons on both sides of the handle,
and lift the handheld vacuum off the wand.
To reattach the handheld vacuum to the
wand, align the nozzle over the top of the
wand and slide it on until it clicks into place.
NOTE: Floor nozzle included is attached to the main unit and can operate only when the power is on.
NOTE: All accessories are compatible with both the wand and the handheld vacuum.
ABOVE-FLOOR WITH ACCESSORY
Attach desired accessory to handheld
vacuum. Press buttons on both sides of the
handle to remove accessory.
Nozzle
Release
Button
Back of
Wand
ABOVE-FLOOR WITH WAND
For more reach to clean above-floor areas,
use the wand directly for suction. To detach
the floor nozzle from the wand, press the
nozzle release button at the bottom of the
wand and lift the wand to remove it.
To reattach the wand, align it over the nozzle
neck, then slide it on until it clicks into place.
To install an accessory, insert it into the wand
until it clicks into place. To remove, press and
hold the nozzle release button and slide out
the accessory.
s h a r k n i n j a . m y