Check Multi Feeding Operation; Checking Multi Feeding Sensor Operation - Brother ADS-3600W Service Manual

When the setting is completed normally, "OK" is displayed on the screen.
If any error is detected during setting, "ERROR" is displayed on the screen.
(9) Unplug the AC power cord of the machine.
3.2

Check Multi Feeding Operation

(1) Press and hold the
ready state. Data display screen appears.
(2) Press the blank field at the bottom. Key input screen appears.
(3) Press the [*], [2], [8], [6], and [4] keys on the LCD in this order to enter the maintenance
mode.
(4) Set the document for multi feeding sensor threshold setting in the ADF unit.
"DOC. READY" is displayed on the LCD.
(5) Press the [0], and then the [8] key. Check that "ADF CHECK P.01" is displayed on the
LCD and the machine ejects the document properly.
(6) When the document is ejected properly, press the
check mode.
(7) Press the [9] key twice in the initial state of maintenance mode. The machine quits
maintenance mode and returns to the ready state.
3.3

Checking Multi Feeding Sensor Operation

Perform the steps below to check the machine's condition after repair or adjustment.
(1) Set the sheet for multi feeding sensor threshold setting in the ADF, and execute the
maintenance mode function "Check ADF" (function code: 08). (To check that a normal
document is ejected correctly.)
key for approximately five seconds while the machine is in the
4-17
key to quit the sensor function
Confidential