Adjust Touch Panel; Setting By Country; Initializing The Eeprom Of The Main Pcb Assy - Brother ADS-3600W Service Manual

(14) Back light of the LCD flashes randomly during the installation. When installing is
completed, the machine restarts and returns to the ready state automatically. Do not
disconnect the USB cable or turn OFF the power switch of the computer until installing is
completed.
(15) Unplug the AC power cord of the machine, and disconnect the USB cable.
1.2

Adjust Touch Panel

(1) Press the [6], and then the [1] key in the initial state of maintenance mode. The
adjustment screen shown below appears on the LCD.
(2) Use a touch panel stylus and touch the mark at the upper left corner of the screen. The
mark disappears when touched, then touch the mark at the lower left. Similarly touch the
mark at the lower right, upper right, and center.
(3) When the center (5th mark) is touched, "OK" is displayed if the specified area was
adjusted correctly. Then, the machine returns to the initial state of maintenance mode.
Note:
• Do not use any tools other than a touch panel stylus. In particular, never use a pointed
tool (e.g. screwdriver). Using such a tool will damage the touch panel.
• Do not touch the touch panel with your fingers. The contact area of a finger is too large
to adjust the touch panel precisely.
1.3

Setting by Country

(1) Check the country code to set in the country code table on page "5-17".
(2) Press the [7], and then the [4] key in the maintenance mode. The country code is
displayed on the LCD.
(3) Enter the country code checked in (1).
(4) Press the [Start] key. The country code is set, and the machine returns to the initial state
of maintenance mode.
1.4

Initializing the EEPROM of the Main PCB ASSY

(1) Press the [0], and then the [1] key in the initial state of maintenance mode.
"PARAMETER INIT" is displayed on the LCD, and the EEPROM is initialized. The
machine returns to the initial state of maintenance mode.
4-5
Confidential