Okofen PELLEMATIC SmartXS Installation Manual page 66

66
Street:
Place:
D D a a m m a a g g e e t t o o p p r r o o p p e e r r t t y y
Use the checklist to check the heating system before
starting up for the first time.
Textile tank
Textile tank
Delivery unit
Filling coupling
Aeration
Caution label
Fire protective collar
Pellematic Smart XS
Burner plate
Flame tube
Sensors
Washer nozzle
Boiler cover
Flue gas pipe
connection
Combustion cham-
ber door
Drain
Aeration/boiler
room
PE 607 USA_FA 2.1
CHECKLIST
Are the struts mounted?
Are all stayers straightened vertical?
Is the slot for the emercency gate valve closed with an ad-
hesive tape?
Are the filling couplings correctly installed?
Are the plugs at the filling couplings?
Are the safety labels placed? (Caution – Switch off the heat-
ing systembefore entering)
Are the couplings correctly grounded?
Is the storage room / building properly ventilated with mini-
mum 27 square inches to the outside?
Is the caution label "Wood pellets storage room" placed on
the door to the storage room?
Are fire protection collars mounted in the storage room?
Is the position of the burner plate correct?
Has the locking screw of the burner plate been tightened?
Has the locking device of the concrete flame tube been
removed?
Is the position of the stainless steel flame tube centred and
upright?
Check the position and fixing of the sensors.
After the start of the boiler, check if the values of the sen-
sors are in a realistic range.
Is the washer nozzle positioned upright?
(The connecting pipe must be positioned horizontally)
Check that the cover of the flue gas collector chamber is
properly fitted, leak-tight and fastened down.
Is the flue gas pipe made of stainless steel?
Is the flue gas pipe leak-tight?
Does the flue gas pipe have a gradient?
No movable parts?
No damper?
Check that the combustion chamber door closes correctly.
Is the connection pipe tight?
Exists the required aeration opening?
Checklist for checking the heating system
Type of accumulator:
Solar device:
Yes Comment