Product Description; Function Description - Okofen PELLEMATIC SmartXS Installation Manual

18
7 7

Product description

The description of the product is intended to provide an overview of the components that make up a MESys
pellet heating system, the parts of the pellet boiler and advice on where you can find more information.

7.1 Function description

The PELLEMATIC Smart XS heating system combines water heating and hot water storage.
Pellets are charged either manually or via the suction system from the storage location into the hoipper, and
from there via the backfire safety device to the drop stage.
The burner auger transports the pellets to the burner plate where the heater rod heats them until they ignite.
The ignition is monitored on the basis of the combustion chamber temperature and switches off once the pel-
lets have ignited.
The fuel and combustion air volume are preset and the vacuum in the combustion chamber is controlled by
means of the flue gas fan. After rising up in the flame tube, the combustion gases are passed down through
the heat exchanger and via the flue gastube and the chimney into the atmosphere.
The heat exchanger is cleaned automatically with the cyclically activated cleaning spring in the heat exchan-
ger. The ash collects underneath the burner plate and is transported by the ash auger into the ash bin.
The combustion chamber and heat exchanger are insulated on the outside. The Pellematic Smart XS has ap-
proximately 4 inches of insulation inside the cladding.
The main components of the PELLEMATIC Smart XS
1
Combination tank with modular interior fittings,
heat exchanger and mounting of the hydraulic
connections
2 Pump group - Not currently used in North
America
3 Fresh hot water module
4
Hopper with vacuum turbine and connection for
the pellet hoses, backfire safety device
PE 607 USA_FA 2.1
5
Burner with burner plate, electric ignition and
ash bin
6
Boiler controller / FA
7
Solar heat exchanger / (Optional)
Product description