Router (Ac Model); Erx-310 Router (Ac Model) - Juniper E Series Hardware Manual

Figure 30: ERX-310 Router, Rear View (DC Model)

ERX-310 router (AC model)

1.
2.
NOTE: To provide redundancy, Power A and Power B leads should not terminate at
the same power source.
3.
Figure 31: ERX-310 Router, Rear View (AC model)
DC power
Power A
leads input A
Ground
Insert the power cord into the AC power IEC receptacle (see Figure 31).
Insert the other end of the power cord into an appropriate AC power source.
Repeat Steps 1–2 for the other power input module, if needed.
POWER A
AC power input A
with switch
Ground
DC power
input B
Power A
switch
100-240V ~ 5A
50/60 Hz
POWER B
AC power input B
with switch
Cabling the E-series Router for Power
Cabling E-series Routers
Power B
switch
63