Factory Default Settings; Technical Support - Emerson Numatics G2-2 Series Quick Start Manual

10) Factory Default Settings

Unless otherwise requested, all standard G2-2 Series A-B 1771 Remote I/O manifolds ship with specific factory
default settings. Below is a list of the factory default settings:
Processor Restart/Lockout
Input Module Power Jumper
Output Module Power Jumper
Valve Side Output Bytes
Discrete I/O Side - I/O Bytes

11) Technical Support

For technical support, contact your local Numatics distributor. If further information is required,
please call Numatics Inc. at (248) 887-4111 and ask for Technical Support.
Issues relating to network set-up, PLC programming, sequencing, software related functions, etc...
should be handled with the appropriate product vendor.
Information on device files, technical manuals, local distributors, and other Numatics, Inc. products
and support issues can be found on the Numatics, Inc's. WEB site at
G2-2 Series A-B 1771 Remote I/O
Description
Rack Address
Baud Rate
Starting Quarter
Hold Last State
3835050 TDG22ABQS3-0
Subject to change without notice
www.numatics.com/fieldbus
Quick Start Manual
Default Settings
57.6 K
Off (Processor Restart)
Off (Reset Outputs)
(Input sensor power supplied by
+24VDC Node and Inputs pin on the Aux. power connector)
(Output module power supplied by
+24VDC Valves and Outputs pin on the Aux. power connector)
4 Bytes (32 Allocated Valve Coil Outputs)
Self-Configuring based on the I/O modules installed.
www.numatics.com
1/07
0
1st
PU
SP
Page 10