Advertisement
Start-up
Contents of this chapter
This chapter describes the start-up procedure of the converter unit. The information is valid
for the example DC/DC converter units presented in the example circuit diagrams.
The underlined tasks are needed for certain cases only. The default device designations (if
any) are given in square brackets, for example, DC switch/disconnector [Q11]. The same
device designations are also used in the example circuit diagrams, typically. They refer to
the circuit diagram of the example installation by ABB.
WARNING!
Only qualified by ABB electricians/engineers are allowed to do the work described
in this chapter. In addition, the electrician/engineer must know the energy storage
system he is about to take into use, and the DC/DC converter control program and
operation principle. Obey all the safety instructions in Safety instructions for ACS880
multidrive cabinets and modules (3AUA0000102301 [English]) and
precautions (page
damage to the equipment can occur.
Before you start, connect a control panel to the DC/DC converter unit. We recommend that
you also have a PC with a drive commissioning tool (Drive composer) connected.
60). If you ignore the safety instructions, injury or death, or
Start-up 75
8
12
Electrical safety
Advertisement
