Advertisement
Installation examples
WARNING!
The code labels attached to mechanical parts such as busbars, shrouds
and sheet metal parts must be removed before installation as they may
cause bad electrical connections, or, after peeling off and collecting dust
in time, cause arcing or block the cooling air flow.
This section instructs in placing the modules and additional equipment into a user-defined
cabinet.
Each example includes a table that lists:
•
installation stages of different equipment in the order in which the installation into the
cabinet should be performed
•
code of the step-by-step instructions
•
equipment kit code
•
kit ordering code.
You can find the kit-specific assembly drawings, step-by-step instructions and kit information
on the Internet. Go to https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content.
If needed, contact your local ABB representative.
The example includes also cabinet assembly drawings that show each stage listed in the
table. More detailed steps of each stage are described in the kit-specific assembly drawings.
For general instructions, see Cabinet design and construction instructions for drive modules
(3AUA0000107668 [English]).
Cabinet construction 37
10
Advertisement
