Os32C Configuration Tool Software; Connecting The Scanner To Your Laptop - Omron TM5M-700 Quick Start Manual

3. OS32C Configuration Tool Software

4.1. Connecting the Scanner to Your Laptop

1. Download and install the OS32C Configuration Tool software from
https://industrial.omron.us/en/products/os32c#downloads.
2. Connect your laptop to the OS32C scanner using the scanner's Ethernet cable.
3. Set your laptop's IP on DHCP. To do this, follow these steps.
a. Click the Windows icon, then type "Change Ethernet settings" and press Enter.
b. Click "Change adapter options" on the right-hand column.
c. Double click on the Ethernet icon that the cable is connected to.
d. Click the Properties button.
e. In the list, scroll down to "Internet Protocol Version 4 (TCP/IPv4)" and highlight it.
f.
g. Click "Obtain an IP address automatically" and "Obtain DNS server address automatically".
h. Click OK to close all windows.
4. Turn off all other wireless network cards such as your Wi-Fi, Bluetooth, etc. To do this, follow these
steps.
a. Click the Windows icon, then type "Change Wi-Fi settings".
b. Turn the Wi-Fi button off.
c. Click the Windows icon, then type "Change Bluetooth and other devices settings".
d. Turn the Bluetooth button off.
5. Click the Windows icon, type "Command Prompt", and when the new window opens, type "ipconfig". It
displays the IPv4 address.
The address shown above in the example will likely not be the same address you will see in your setup.
6. Open OS32C Configuration Tool.
7. Wait for about a minute or two to read the IP addresses of the laptop and scanner.
Click the Properties button.
Omron TM Collaborative Robot: Safety Laser Scanner Installation – Ver. 1
Omron Automation │©2019 Omron. All rights reserved. │automation.omron.com
Page 6 of 11