HP Adaptive Rack Cooling System System Installation Manual page 31

For more information on the HPE ARCS Auto Door Release Kit and HPE ARCS Auto Door Controller Kit
contents, see Accessory and option kit contents.
NOTE: To install these option kits, a rack PDU plug must be available for a C13/C14 power cable to be
installed. One c13 PDU outlet is required.
To install the HPE ARCS Auto Door Release and Controller Kits:
1. Remove the existing striker plate from the front door.
2. Align the new striker assembly with the large reference whole on the front extension. Then use the
set of three M5.5X10 Torx pan head tap screws that are included with the kit to install the striker
assembly.
3. Align the front door latch assembly with the screw holes on the front door. Ensure that the actuating
pin is under the door latch. Then use two 1/4-20 button head screws to install the front door latch
assembly.
Configuration 31