Page of 2
   
Hewlett-Packard Storage Processor (SP)
Hewlett-Packard SPs are customer installable and replaceable. A replacement SP must be the same type as the SP being
replaced.
The locations of the SPs in the 30-slot disk arrays are shown in Figure 1.
.
SP-A
Install an SP by performing the following steps. Place a check in the appropriate
Step 1:
Observe antistatic precautions
An SP is shipped with an ESD kit containing:
ESD wrist strap
ESD conductive sheet
Ground the ESD wrist strap to the metal edge above the
rear retaining screws and fasten the strap to your wrist.
Installation Guide
Rear view, top of the disk array
Figure 1.
Step 2:
as the step is completed.
Prepare to install the SP
Remove the replacement SP from its shipping carton
and place it on a suitable antistatic work surface or the
ESD conductive sheet.
Array power can be left on during SP removal and
replacement.
Remove the failed SP.
Remove the memory modules from the failed SP.
Insert memory modules in the SIMM connectors on the
SP to be installed.
See the
SIMM removal and replacement.
SP-B
chapter in the
for more information about

Advertising

   Summary of Contents for HP A3550A - High Availability Disk Arrays Model 20 Storage Enclosure

  • Page 1

    Hewlett-Packard Storage Processor (SP) Installation Guide Hewlett-Packard SPs are customer installable and replaceable. A replacement SP must be the same type as the SP being replaced. The locations of the SPs in the 30-slot disk arrays are shown in Figure 1.

  • Page 2

    Press both ejectors until they lock and the SP seats completely slide it into the chassis until the ejectors engage with into the chassis. the chassis edge. Figure 2. Manual Part Number Copyright © 1997 A3662-90001 E0897 Hewlett-Packard Company *PA3662-96001* A3662-96001...

This manual also for:

A3550a 20

Comments to this Manuals

Symbols: 0
Latest comments: