Initial Configuration - Dataprobe iBoot-DC Manual

4.1. Auto-Configuration
If your network supports
Protocol (DHCP), the iBoot will be automatically
assigned an IP Address and be ready to use. You
can discover the
Server/Router, or
Management Utility (DMU).
4.2. Device Management Utility
The DMU
dataprobe.com/support-iboot-dc/,
easiest means to find and configure your iBoot-DC
for use. It can:

Discover all the iBoots on your network,

Display the current IP address of each

Allow setting of an IP address

Reset to Factory Defaults

Upgrade the Firmware of the iBoot-DC
Obtain and use the DMU:
1. Download the latest version of the DMU at
dataprobe.com/support-iboot-dc/
2. Run DMUSetup.exe
3. Run the DMU
Note: The IP address can only be set within the first
two minutes of powering up the iBoot-DC or pressing
the reset button (see Section 11). The Setup Utility
will only work with iBoots on the same physical
subnet as the PC.
Once the DMU is run, click on Device | Discover to
display all the iBoots on your network. The DMU will
display the Location Name of the iBoot, The product
ID and Version Number, the current IP Address, and
the MAC Address.
display with the name iBoot-DC-xxxx where the
xxxx are the last 4 segments of the MAC address,
and have the factory default IP address
192.168.1.254, or as set by DHCP.
The IP address field also indicates the port for web
access that is used by the iBoot. The standard port
for web browser control is factory default Port 80.
iboot-dc_v181024e
4.

Initial Configuration

Dynamic Host Configuration
IP Address through
use Dataprobe's
is available online
provides
Factory defaulted iBoots will
your
Device
at
the
of
iBoot-DC
DMU Discovers Dataprobe Devices
on your Network
Enter New IP Address for iBoot
IP Address Successfully Set
Page 6