Dataprobe iBoot-DC Manual page 22

login
logout
reboot
Network Commands
get network
set ipmode <static | dhcp>
set ipaddress <dotted
decimal>
set subnet <dotted decimal>
set gateway <dotted decimal>
set http port <0-65535>
set telnet port <0-65535>
set dxp port <0-65535>
set linkback <url>
set timeout <0-999>
iboot-dc_v181024e
Prompts for admin credentials when logged in as user
Terminates the session
This command reboots the iBoot-DC.
All set commands require a reboot before they take effect. These commands
are only available to the administrator.
This command will return all the network settings as shown
below:
Mode: DHCP
IP Address: 192.168.1.254
Subnet: 255.255.255.0
Gateway: 192.168.1.1
DNS: 8.8.8.8
HTTP Port: 80
Linkback URL:
Telnet Port: 23
DxP Port: 9100
Timeout: 20
This command sets the ip address setting mode. Static mode
locks the address as set, dhcp mode allows DHCP server to
assign address.
This command is used to set the iBoot-DC's ip address.
This command is used to set the iBoot-DC's subnet mask.
This command is used to set the Gateway
This command sets the port that the iBoot-DC's web server
listens for incoming connections on. When set to 0 the web
server is disabled.
This command sets the port that the iBoot-DC's Telnet server
listens for incoming connections on. When set to 0 the Telnet
server is disabled
This command sets the port that the iBoot-DC's DxP protocol
service listens for incoming connections on. When set to 0
the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The CLI
will protect against all 3 from being set to 0.
This command sets the linkback URL displayed on the logout
page.
This command sets the automatic network timeout in minutes
0 = Timeout not used.
iBoot-DC
DHCP
192.168.1.254
255.255.255.0
192.168.1.1
80
23
9100
2
Page 22