Table of Contents
Advertisement
6.4.1
Set the Total Number of Load Cells
1. Press
and
F1
2. Press
to scroll to
F2
3. Press
F1
4. Press
. The total number of remote devices is displayed.
F1
5. Press
to scroll through numbers and
F2
6. When correct number of remote displays attached (1-4) is displayed, press
does not include the MSI-8000HD or any modems.
7. Press
. The load totaling setting displays.
F1
8. Press
to scroll through numbers and
F2
9. Press
.
F1
10. Press
twice to exit to the weighing mode.
ZERO
6.4.2
Scan Weight Inputs
1. Program
to the
F1
2. The current channel is displayed, press
displayed briefly, then the scan channel weight is displayed.
3. Press
. In a two sensor system the scan returns to the first channel (0).
F1
6.4.3
Load Totaling Settings
There are four different types of load totaling modes and are explained below.
All
All channels are added together, press to view the sum of all sensors connected. Pressing again
confirms that the summed channels are being displayed, by briefly displaying
If the sum is the only thing to be observed, disable the Scan function key using the function key setup menu
Note
(Section 4.2 on page
Pairs
Used with four sensor systems, scrolling through the channels with
and then as pairs. This display is proceeded by the LCD message
Both
This mode displays both the pair totals and the overall total. Each press of
combinations. First
, then
F3
at the same time.
PRINT
.
is displayed.
displays.
function, and
to the
F2
F1
9).
then the sum of all connected sensors is displayed.
is displayed.
to save the selected numbers.
F1
displays.
to save the selected numbers.
F1
function for summed sensor readings. See
to change to the next channel. The scan channel number is
(total remote sensor devices).
ttl.rd
, they will be presented as separate weights first
and
© Rice Lake Weighing Systems ● All Rights Reserved
Communications Setup
. See
Section
4.2.8.
F1
Section
.
scrolls through the summed
This number
6.4.3.
27
Advertisement
Table of Contents
