14
• Press the UP/DOWN button to select one off the following parametres:
- Reset - To start a preset program to restore the selected function (All, Pan, Tilt, Zoom).
- Adjust - To allows you to change all parameters. To access this mode, enter the password "050".Select
the desired function (Pan Offset, Tilt Offset, Zoom Offset) and the choose the value (0 - 255).
- Factory Reload - To reset the unit. Select Yes or No and select RIGHT to confirm.
• Press the RIGHT button to confirm the selection and wait for the selected function to be restored.
• Press the LEFT button repeatedly to exit the menu and to save the changes made.
3.14 INFORMATION ON THE DEVICE
To view all the information on the device, proceed as follows:
• Press the LEFT button to access the main menu. Press the UP/DOWN button to select Information, then
press the RIGHT button to access the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information-
and press the RIGHT button to display it.- Fixture Time - Through the Fixture Time function, the operat-
ing time of the projector can be shown on the display.
- Fixture Time - To view the operating time of the projector.
- Temperature - To view the temperature of the device in °C on the display.
- Fans Speed - to view on the display the fan speed present near the lamp.
- Software Version - To view the firmware version will show on the display.
- UID - To view the identification ID for the RDM control.
3.15 DMX VIEW
Select the View DMX function to display the DMX values received by the fixture for each channel during
its operation.
PIXIEWASHXB