Dmx Configuration; Wireless Settings; Ethernet - ProLights PIXIEWASHXB User Manual

3.5 DMX CONFIGURATION

The PIXIEWASHXB has 6 DMX channels configurations selectable through the control panel.
• Press the button LEFT to enter the menu mode.
• Use the buttons UP/DOWN to select the Connect. Press the button RIGHT to confirm.
• Press the buttons UP/DOWN to select the DMX mode. Then press the button RIGHT to confirm.
• Press the buttons UP/DOWN to select the desired configuration (STANDARD-13CH, STANDARD-15CH, STAND-
ARD-16CH, EXTENDED-18CH, EXTENDED-22CH, EXTENDED-23CH) then press the button RIGHT to save.
• Press repeatedly the button LEFT to return the menu mode.
The tables on page 15, 16, 17, 18 indicate the operating mode and DMX value. The PIXIEWASHXB is
equipped with 5-pole XLR connections.

3.6 WIRELESS SETTINGS

• To enter the Wireless mode press the LEFT button until the display shows Connect, then select Wireless
using the RIGHT button.
• Select the Wireless Receive function using the UP/DOWN buttons, then press the RIGHT button.
• To activate the Wireless Receive function, use the UP/DOWN buttons and select the On option.
• Press the RIGHT button to confirm the selection.
• Press the LEFT button to go back or wait a few seconds to exit the setup menu.
NOTE - Once you have performed these steps, you must synchronize with any WiFi unit with which you
want to communicate by pressing the sync button on it. At this point connect the DMX console to the
WiFi unit to open the communication with the PIXIEWASHXB.
• To reset the unit, select the Receive Reset function using the UP/DOWN buttons, press the RIGHT button
until the display shows Connect, then select Receive Reset using the UP/DOWN buttons, then press the
RIGHT button.
• To activate the mode use the UP / DOWN keys and select the Yes option.
• Press the RIGHT button to confirm the selection.
• Press the LEFT button to go back or wait a few seconds to exit the setup menu.
• To activate the Wireless to DMX function, use the UP / DOWN buttons to press the RIGHT button until the
display shows Connect, then select Wireless to DMX, then press the RIGHT button.
• To activate the mode use the UP/DOWN buttons and select the Yes option.
• Press the RIGHT button to confirm the selection.
• Press the LEFT button to go back or wait a few seconds to exit the setup menu.

3.7 ETHERNET

For the ArtNet settings to be assigned to the unit, refer to the following menu section.
• Press the UP/DOWN button to scroll through the menu, select Connect, then press the RIGHT button ac-
cess the next Ethernet menu with the UP / DOWN button, then press the RIGHT button.
• Use the UP/DOWN buttons to select one of the following settings: Universe, Start Channel, IP Address, Eth-
ernet to DMX.
• Press the RIGHT button to confirm the selection and enter the sub menu.
• To activate the Ethernet to DMX function, use the UP / DOWN buttons to press the RIGHT button until the
display shows Connect, then select Ethernet to DMX, then press the RIGHT button.
• To activate the mode use the UP/DOWN buttons and select the Yes option.
• Press the RIGHT button to confirm the selection.
• Set the desired value for the selected function using the UP/DOWN buttons. Then press the RIGHT
button.
• Press the LEFT button to go back or wait a few seconds to exit the setup menu.
PIXIEWASHXB
11