Removing/Installing Faceplate - Woodstock Shop fox W1856 Owner's Manual

Model W1856 (For Machines Mfd. Since 02/19)
Removing/Installing.
Faceplate
These instructions cover removing and installing the
faceplate. To mount a workpiece to your faceplate, refer
to Faceplate.Turning on Page.28.
Items.Needed.
Open-End Wrench 32mm.......................................1
Knockout Rod ....................................................1
Removing.Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. Put open end of wrench over flats behind faceplate.
While holding spindle in place with knockout rod,
turn wrench counterclockwise until faceplate is
removed (see Figure.18).
Note: If the spur center is installed, it will be
removed during this process.
Installing.Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. While holding spindle in place, thread faceplate
clockwise onto spindle shaft until secure against
shoulder on spindle shaft.
3. Insert knockout rod into one hole on spindle, then
tighten/secure faceplate with open-end wrench (see
Figure.18).
To. prevent. faceplate. and. workpiece.
separating.
Qty
operation,. headstock. faceplate. MUST.
be. firmly. threaded. onto. spindle. and.
secured. in. place.. If. these. instructions.
are. not. properly. performed,. serious.
personal.injury.could.occur.
Knockout
Rod
Figure.18. Removing faceplate.
-23-
from. spindle. during.
Faceplate