Installing Faceplate - Woodstock W1866 Owner's Manual

Model W1866 (For Machines Mfd. Since 11/18)
Installing.Faceplate
To install faceplate, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Rotate spindle lock right to prevent spindle from
turning while you tighten faceplate, as shown in
Figure 29.
3. Thread faceplate onto spindle until it is snug (see
Figure 30).
4. Tighten (2) M6-1 x 10 set screws along inside
diameter of faceplate to secure it to spindle (see
Figure 30).
Note: To remove faceplate, disconnect lathe from
power source and perform steps above in reverse.
5. Rotate spindle lock left to unlock spindle.
To. prevent. faceplate. and. workpiece.
separating.
operation,. headstock. faceplate. MUST.
be. firmly. threaded. onto. spindle. and.
secured. in. place. by. fully. tightening.
the. two. faceplate. set. screws.. If.
these. instructions. are. not. properly.
performed,. serious. personal. injury.
could.occur.
Spindle
Lock
Figure.29. Location of spindle lock.
Figure.30. Location of faceplate set
Never. resume. turning. operations.
without. making. sure. that. spindle. lock.
is. disengaged. and. spindle. turns. freely.
by.hand..Otherwise.personal.injury.or.
property.damage.could.result.
-31-
from. spindle. during.
Faceplate Faceplate
Set Screws
screws.