Pairing the earbuds with a Bluetooth
Before you can use the earbuds
patible Bluetooth
♦
Make sure that the earbuds
device is switched on.
♦
Set the Bluetooth
devices. A detailed description of how to do this can be found in
the operating instructions for your Bluetooth
♦
Press and hold the multifunction switch
earbuds
for 6 seconds to turn the earbuds
the Bluetooth
Connected Left channel / Right channel" and the operating/
charging LED
blue. At the same time, the operating/charging LED
earbud
flashes every 5 seconds. The left earbud
headphone and establishes the Bluetooth
Bluetooth
♦
Select SIBT 16 A1 from the list of found devices on your Bluetooth
device to pair the two devices. You will hear the message "Pairing
successful – Connected" if the pairing was successful.
NOTE
►
If you do not establish a connection between the earbuds
and your Bluetooth
message "Power off" and the earbuds
cally. In this case, you will have to switch the earbuds
on again before starting the pairing process again.
│ GB │ IE │ NI
■
16
device.
®
appliance so that it scans for other Bluetooth
®
function. You will hear the message "Power on –
®
on the left earbud
device.
®
device within 2 minutes, you will hear the
®
, you must pair them with a com-
are switched off and the Bluetooth
on the left and right
flashes alternately red and
®
switch off automati-
®
device
device.
®
on and activate
on the right
is the main
connection with the
back
SIBT 16 A1
®
®
®