Pairing The Headphones With Two Bluetooth Devices; Using A Wired Headphones Connection - Silvercrest SBTH 4.1 A1 Operating Instructions And Safety Instructions

As soon as the previously paired device moves into the headphone range the
connection is established automatically. It may be necessary to confirm this
connection on your device.
Pairing the headphones with two Bluetooth
devices
You can pair the headphones with two Bluetooth
the headphones have already been paired with one device, proceed as
follows to pair a second device:

Power the headphones off and disable Bluetooth

Power the headphones back on and pair the 2nd device as described in
the previous chapter "Pairing the headphones".

After a successful pairing, enable Bluetooth
connection between the headphones and the first device is established
automatically.

Using a wired headphones connection

You can also use the supplied 3.5mm jack-type audio cable (C) to connect
your headphones (A) to the audio source. To do this, insert one end of the
3.5mm jack-type audio cable (C) into the 3.5mm audio jack (9) and then
connect the other end to your audio source. When connected via cable, the
headphones work like any other non-Bluetooth
used when its battery is discharged. In this case, adjust the volume directly on
the audio source. The headphone (A) buttons have no function in this mode.
SilverCrest SBTH 4.1 A1
®
devices at the same time. If
®
on the first device.
®
on the first device. The
®
headphones and can also be
®
English - 73