Cable System Or Vhf/Uhf Antenna System; Cable Box - Sony GRAND WEGA 2-694-282-13(1) Operating Instructions Manual

Cable System or
VHF/UHF Antenna
System

Cable Box

Notes on Using This Connection
To do this...
Use the cable box
Set up the TV remote control to operate the cable
box
Activate the remote control to operate the cable
box
Prevent the accidental switching of TV channels When using the cable box, ensure that the TV remains tuned to the
20
For best results, use this connection if you:
❑
Have a cable or an antenna.
❑
Do not have a cable box or VCR. (If you have a cable box, see below. If
you have a VCR, see pages 25 and 26.)
75-ohm Coaxial cable
✍
Do not use an indoor antenna, which is especially susceptible to
radio noise.
For best results, use this connection if:
❑
Your cable company scrambles all channels, which requires you to use a
cable box.
❑
You do not have a VCR. (If you have a VCR, see pages 25 and 26.)
To connect the cable box
1
Connect the CATV cable to the cable box's input jack.
2
Use a coaxial cable to connect the cable box's output jack to the TV's
CABLE input.
3
Turn on the cable box first, then run Auto Program as described in
"Setting Up the Channel List" on pages 23.
CATV cable
Coaxial cable
IN
Cable box
Do This ...
Tune the TV to the channel the cable box is set to (usually channel 3
or 4) and then use the cable box to switch channels.
Program the remote control. See "Programming the Remote
Control" on page 35.
Press SAT/CABLE (FUNCTION) once, and the SAT/CABLE
indicator lights up.
channel that the cable box is set to (usually channel 3 or 4).
Rear of TV
VHF/UHF
CABLE
OUT
Rear of TV