Setting Up The Channel List; Using Initial Setup - Sony GRAND WEGA 2-694-282-13(1) Operating Instructions Manual

Setting Up the Channel List

Using Initial Setup

After you finish connecting the TV, you can run the Initial Setup to create a
list of available channels. The Initial Setup screen appears when you turn on
the TV for the first time after hooking it up. If you choose to set up the
channels at a later time, select the Auto Program option in the Channel
setting to scan available channels (see below).
✍
The Initial Setup feature does not apply for installations that use a
cable box for all channel selection.
To run Initial Setup the first time you turn on your TV
1
TV POWER
Press to turn on the TV.
The Initial Setup screen appears.
2
Press V or v to highlight the on-screen
display language. Then press
message "First please connect cable or
antenna" and "Start auto program now?"
will appear.
3
Highlight "Yes" then press
Auto Program performed through Initial Setup will automatically create a
list of receivable channels.
✍
Auto Program may take a few minutes to complete. If you cancel
the Auto Program before all receivable channels are scanned, you
may want to perform the task later (see "To run Auto Program at a
later time" below).
✍
If you selected "No" during the Initial Setup, the Initial Setup
message will appear each time you turn on the TV until you
complete the Auto Program as a reminder.
To run Auto Program at a later time
Before running the Auto Program, make sure that you have selected the
correct signal input for your TV. See "Cable" under Selecting Channel
Options on on page 56.
1
Select Settings in MENU, and then go to Channel settings.
2
Select Auto Program then select "Yes".
✍
Auto Program will create a list of receivable channels for the
current input (VHF/UHF antenna or CABLE).
Initial Setup
First please connect cable or antenna.
Start auto program now?
. The
Yes
Move: Select:
.
No
Exit:
MENU
23