Connecting The Tv; Cable System And Vhf/Uhf Antenna System; Cable Box/Digital Cable Box And Antenna - Sony WEGA KDS-R60XBR2 Operating Instructions Manual

Getting Started
Connecting the TV
To display clear crisp pictures, you must connect your TV correctly and
select the correct Wide Mode to display the picture in the correct aspect
ratio (see "Changing the Wide Screen Mode" on page 31 ). It is strongly
recommended that you connect the antenna/cable input using 75-ohm
coaxial cable to receive optimum picture quality signal. A 300-ohm twin
lead cable can be easily affected by radio noise and the like, resulting in
signal deterioration. If you use a 300-ohm twin lead cable, keep it as far
away from the TV as possible. Do not use an indoor antenna, which is
especially susceptible to radio noise.
You can also connect a variety of optional equipment to your TV (see page
17). For multiple equipment connections, please refer to the separate Quick
Setup Guide.
Cable System and
VHF/UHF Antenna
System
VHV/UHF
Antenna cable
CATV cable cA_
!._ Press ANT to switch between VHF/UHF and cable.
Cable Box/Digital
Cable Box and
Antenna
_" To change channels
using the cable box, set
your TV to channel 3 or
4 depending on the
cable box channel
output.
Use this hookup if
VI Your cable company scrambles some channels, such as premium
channels. Viewing all channels requires a cable box.
VI You do not intend to hook up any other audio or video equipment to
your TV.
CATV cable
Ilmll_l_l_ ,N OUT _1_ _ m
Antenna
I_ _'_1 _ | | cable
Cable box Coaxiall _
cable __F
CABLE
Rear of TV
'/_ To set up the TV remote control see "Programming the Remote
Contror! on page 321
_,_ Press SAT!CABLE to begin operating the cable box wit h the remote
contr0! (se e page 28). The indicat0r will light up,
f'-_ Press ANTtoswitch between VHF/UHF and cable.
16