Programming the Remote Control
POWER TV POWER
TOP MENU MENU
The remote control is preset to operate Sony brand video equipment.
BD (Blu-ray Disc)/DVD
Follow the steps below to program your TV's remote control to operate non-
Sony video equipment.
Find the three-digit code for your equipment from the "Manufacturer's
Codes" listed on page 36. If more than one code number is listed, try
entering from the code listed first.
1 Press and hold the
program on the remote control and press the
SAT/CABLE) will flash.
2 Enter the three-digit manufacturer's code number using the --9
10 seconds, you must start from step 1 again.
3 Press the
When the programming is correct, the selected
flashes twice. When not correct, the button flashes five times.
program any of your connected equipment using any one of the
buttons regardless of the label. For example,
programmed to operate your VCR. If you have a DVD/VCR combo
that you want to operate with your TV remote control, you can
program with the
button you have programmed for your particular use.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
button. If the equipment turns on and off, the programming is completed. If
not, try the next code listed.
If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically
goes back to the previous setting.
In some cases, you may not be able to program your remote
control to operate other equipment. In such cases, use the
equipment's own remote control.
Programmable Code Number
901 (Sony Dream System)
801 (Sony Satellite Receiver)
button (BD/DVR, VCR/DVD or
button is lit. If the code is not entered within
buttons are labeled as such, you can still
or even the
button you want to
button can be
, but remember which