IBM Power System 5148-22L Manual page 140

2. Type iprconfig on the command line of the Linux session and press Enter. The IBM Power RAID
Configuration Utility display is shown.
3. Select Work with disk unit recovery from the IBM Power RAID Configuration Utility display. Press
Enter. The Work with Disk Unit Recovery display is shown.
4. From the Work with Disk Unit Recovery display, select Rebuild disk unit data.
A Rebuild Disk Unit Data display similar to the following example is shown.
Select the disks to be rebuilt
Type choice, press Enter.
1=Rebuild
OPT Name PCI/SCSI Location
--- ------ -------------------------- ------------------------- -------------
1 0000:58:01.0.0/0:4:0
e=Exit q=Cancel t=Toggle
Figure 113. Example Rebuild Disk Unit Data display
5. Type 1 (Rebuild) next to the disk drive you want to rebuild and press Enter.
Note: Completing a rebuild on a drive overwrites the data currently on the drive.
A Confirm Rebuild Disk Unit Data display similar to the following example is shown.
Rebuilding the disk unit data might take several minutes for each disk
selected.
Press Enter to confirm having the data rebuilt.
q=Cancel to return and change your choice.
OPT Name PCI/SCSI Location
--- ------ -------------------------- ------------------------- ---------------
1 0000:58:01.0.0/0:4:0
q=Cancel t=Toggle
Figure 114. Example Confirm Rebuild Disk Unit Data display
6. To confirm that you want to rebuild the data on the drive, press Enter.
The message that the rebuild started is shown at the bottom of the Work with Disk Unit Recovery
display. The rebuild process might take several minutes to complete.
122
Disk drives or solid-state drives
Rebuild Disk Unit Data
Description
RAID Array Member
Confirm Rebuild Disk Unit Data
Description
RAID Array Member
Status
Failed
Status
Failed