Keiser M3X User Manual page 9

MOUNTING COMPUTER
Step 1: Obtain the 3mm Allen wrench and remove the computer mounting screw from the
handlebar casting (Fig. 20). Keep the mounting screw.
Step 2: Slide the computer up into the two locking ears. Fit the computer wire into the slot on the
handlebar casting (Fig. 21). Insert and tighten the screw removed in Step 1 using the 3mm Allen
wrench (Fig. 22).
ROUTING THE COMPUTER ASSEMBLY WIRE
Step 1: Ensure the computer assembly wire is fed through the slot of the sweat seal (Fig. 23).
Step 2: Plug in the modular connector to the coupler sitting on the X-Bar hole (Fig. 24)
Step 3: Turn the X-Bar resistance to the lowest level by turning the knob to the minus side until
stop (Fig. 25).
Step 4: Shift the X-Bar to the right most position facing the X-Bar by pulling the handlebar as
shown (Fig. 26).
Step 5: Fit the computer wire into the wire clip while ensuring the computer wire is about 3/4" or
19mm away from the X-Bar center linkage (Fig. 27 & 28).
Step 6: Shift the X-Bar to both side multiple times to ensure the computer wire is not hitting sharp
corners or being stretched too tight.
20
23
21
24
Fig. 26-28 next page
22
25
8