Table of Contents
Advertisement
M3X ASSEMBLY
ASSEMBLING MAIN FRAME TO BASE FRAME
Step 1: Carefully lower the main frame onto the base frame over the base screws, with the front
of the bike facing the transport wheels on the base frame. (Fig. 1)
Step 2: Insert one washer on each of the four base frame studs. (Fig. 1)
Step 3: Install the acorn nuts on the studs and hand tighten. Torque the acorn nuts with a 16mm
or 5/8" crowfoot and torque wrench to 47 Nm (35 ft-lbs) using a 16mm, or 5/8 inch open-end
wrench to hold in position. (Fig. 2)
1
ASSEMBLING FLYWHEEL, HUB, AND HUB CAP
Step 1: Before starting the assembly of the flywheel, hub, and hub cap, make sure that the shifter
lever is in the downward position. (Fig. 3)
!
NOTE: Not following this step may scratch the flywheel.
Step 2: Remove the plastic wrapping from around the axle, hub, and hub cap. Remove the hub
cap. Obtain the 5 socket head cap screws (M6x1 X 20 SS) and 5mm Allen wrench. (Fig. 4)
Remove the flywheel from its foam envelope.
3
2
4
4
Advertisement
Table of Contents
