Table of Contents
Advertisement
MOUNTING X-BAR
Step 1: Unpack the X-Bar from the cardboard box and carefully lay it out on a clean soft surface.
Step 2: Loose front cover screws with a 4mm Allen wrench and remove front cover carefully (Fig.
8). Keep the cover and screws aside for reassembling.
Step 3: Loose lower cover screws with a 2.5mm or 4mm Allen wrench and remove lower cover
carefully (Fig. 9). Keep the cover and screws aside for reassembling.
Step 4: Obtain the 4 socket head cap screws M8x1.25 X 20 SS, 4 aircraft washers 5/16, and 4
hex elastic lock nuts M8x1.25 SS.
Step 5: Unplug the modular connector coupler from the computer wire. Pull out the modular
connector from the mounting bracket and plug it into the coupler (Fig. 10). Hold the X-Bar close to
the mounting bracket and feed the coupler through the round hole on the X-Bar casting (Fig. 11).
Step 6: Hold the X-Bar and align the mounting holes of the X-Bar to the holes of the mounting
bracket. Set in the screws, washers and nuts and hand tighten as shown (Fig. 12).
Step 7: Tighten all four nuts with the 13mm combination wrench while holding the screws with
the 6mm Allen wrench (Fig. 13).
Step 8: Set the coupler back in the hole as shown (Fig. 14). Do not push it deep into the mounting hole.
8
11
WASHER
9
12
14
10
13
6
Advertisement
Table of Contents
