Arc Ignition Set (For Plasma Cutting) - Promotech DRAGON Operator's Manual

5.15. Arc ignition set (for plasma cutting)

Allows control of one torch by using the arc ignition cable.
Part number (arc ignition set):
ZSP-0475-58-00-00-0
To install, place the arc ignition set into the carriage slot, and then tighten the set with
the 4 mm hex wrench and the M5x50 screw. Next, plug the cable into the socket and
connect the brown wire to the first terminal of the cutting circuit, and connect the blue
wire to the second terminal of the same circuit, according to the diagram shown in
the figure.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
This document is protected by copyrights.
26
Part number (arc ignition cable, 6.5 m, 22 ft):
KBL-0475-58-05-00-0
Cutting circuit
DRAGON (HS)