Table of Contents
Advertisement
5.2. 1000 mm (39'') rack
Increases the reach of the torch holder.
Part number:
RAM-0475-23-00-00-0
To remove the installed rack, use the 3 mm hex wrench to loosen the set screw and
remove the counterweight. Then, loosen the handle of the torch holder and remove
the holder. Next, unlock two rack locking levers and rotate the rack position knob to
move the rack out of the carriage body. Install in reverse order. Position the rack teeth
sideways to engage them with the gear of the knob. Note that using the 1000 mm (39'')
rack may also require the roller support or 2.6 kg counterweight to balance the carriage.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
This document is protected by copyrights.
14
DRAGON (HS)
Advertisement
Table of Contents
