Table of Contents
Advertisement
5.8. Circle cutting attachment for 240–1000 mm radius
Allows cutting holes with the radius of 240–1000 mm (0.8–3.3 ft; when used with the
standard rack). To install, use the 3 mm hex wrench and unscrew two front screws
from the bottom plate, and then use them to tighten the bracket to the exposed holes.
Next, use the 4 mm hex wrench to fix the arm to the side wall with two M5x16
screws. Set the pilot pin above the center of the circle and turn on the magnet with
the magnet lever.
Bracket
5.9. Circle cutting attachment for 400–2500 mm radius
Allows cutting holes with the radius of 400–2500 mm (1.3–8.2 ft; when used with the
standard rack). To install, use the 3 mm hex wrench and unscrew two front screws
from the bottom plate and use them to install the bracket. Next, use the 5 mm hex
wrench to install the arm to the side wall with two M6x30 screws. Place the tip of the
pilot pin in the center of the circle and lock the levers of the clamping blocks.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
This document is protected by copyrights.
20
Part number:
CYR-0475-22-00-00-0
Magnet lever
Pilot pin
Part number:
CYR-0475-83-00-00-0
DRAGON (HS)
Advertisement
Table of Contents
