Gas Manifold Bracket (For Oxy-Fuel Cutting) - Promotech DRAGON Operator's Manual

5.14. Gas manifold bracket (for oxy-fuel cutting)

Allows use of a second gas manifold. Use the 5 mm hex wrench and M6x8 screws to
tighten the bracket to the side wall or, if used with the cable anchor, use the 5 mm
hex wrench and M6x30 screws to tighten the bracket between the cable anchor and
the side wall.
Part number:
PDT-0475-87-00-00-0
Copying, using, or distributing without permission of PROMOTECH is prohibited.
This document is protected by copyrights.
25
DRAGON (HS)