Precise Torch Holder; Machine Torch Holder (For Oxy-Fuel Cutting) - Promotech DRAGON Operator's Manual

5.6.2. Precise torch holder

Designed for torches with the handle diameter of 28–35 mm (1.10–1.38'') and allows
precise adjustment of the torch angle. The knob can be installed at either side after
loosening the set screw and is used to adjust the vertical position of the torch. To
adjust the resistance of the vertical motion, use the 2.5 mm hex wrench and unscrew all
fixing screws, and then use the 2 mm hex wrench and adjust the adjusting screws.
Set screw
Part number:
UCW-0475-08-00-00-0

5.6.3. Machine torch holder (for oxy-fuel cutting)

Designed for torches with the handle diameter of 30 mm (1.18'') or 35 mm (1.38'')
equipped with a rack. The holder allows adjustment of the vertical position of the torch
by using the knob and rough adjustment of the angle.
Part number (30 mm):
UCW-0475-61-00-00-0
Part number (35 mm):
UCW-0475-29-00-00-1
Copying, using, or distributing without permission of PROMOTECH is prohibited.
This document is protected by copyrights.
17
Fixing screws
DRAGON (HS)
Adjusting screws